S6 Wagon L5-2226cc 2.22L DOHC Turbo (AAN) (1995)
/Page-1770002.png)
Engine Control Module Harness Connector
-
Repair open circuit or short circuited wires between sensor harness connector and the ECM connector (terminals 48/49 and 19), if necessary.
If OK:
-
Visually check teeth on starter ring gear.
-
Remove bracket with RPM sensor and Crankshaft Position (CKP) sensor and inspect.
-
Rotate engine slowly and examine ring gear for runout and broken and/or damaged teeth, replace if necessary.
If OK:
-
Replace the ECM.
