S6 Wagon L5-2226cc 2.22L DOHC Turbo (AAN) (1995)
Air Bag: Service and Repair
Passenger Side
-
Disconnect single-pin airbag power supply connector.
-
Remove glove compartment
-
Loosen hex nuts -6- and remove air- bag mounting plate -5-.
^
Tightening torque: 6 Nm (53 in lb)
-
Loosen hex bolt -4-.
^
Tightening torque: 15 Nm (11 ft lb)
-
Disconnect electrical connector -8
-
and remove airbag -3-.
WARNING:
^
Connection -7- (2 pin, red), on the airbag unit must NEVER be disconnected.
^
If connection -7- is loose, replace the airbag unit
^
Always replace the airbag with front side up.
-
Loosen hex bolts -2- and remove mounting bracket -1-.
^
Tightening torque: 15 Nm(11 ft lb)
-
Install in reverse order of removal.
NOTE:
^
Airbag mounting plate -5- MUST be installed to ensure normal function of the passenger airbag.
^
When installing the airbag always replace hex bolt -4- with a new one. Verify that bolt/nut threads are clean.