S8 Quattro Sedan V10-5.2L (BSM) (2009)
-
Using a Multimeter, check the following wiring connections for voltage.
-
Switch the ignition off.
If the specification is not obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623).
-
Using a Multimeter, check the Throttle Position (TP) Sensor (G79)/Accelerator Pedal Position Sensor 2 (G185) electrical harness connector
terminals to the Motronic Engine Control Module (ECM) (J623) electrical connector T94a for an open circuit according to wiring diagram.
Specified value: 1.5 ohms max.
If the specification is not obtained:
-
Check the wiring for a short circuit to each other, Battery (+), and Ground (GND).
-
Check the electrical harness connector for damage, corrosion, lose or broken terminals.