S8 Quattro Sedan V10-5.2L (BSM) (2009)
/Page-793002.png)
-
Disconnect the Intake Manifold Runner Position Sensor 2 (G512) electrical harness connector - 1 -.
Switch the ignition on.
-
Using a Multimeter, check the Intake Manifold Runner Position Sensor 2 (G512) electrical harness connector for voltage.
Switch the ignition off.
If the specified values are obtained:
-
Replace the Intake Manifold Runner Position Sensor 2 (G512).
If specified values are not obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
