TT L4-1.8L Turbo (BEA) (2004)
Front Door Window Motor: Service and Repair
Basic Setting For Window Regulator Motor, Activating
NOTE:
-
The following repair procedures must be completed after installation of replacement parts.
-
All sealing and trim must be fully installed.
-
Door and window regulator must be adjusted.
-
Door must be fully assembled and closed.
-
Follow the subsequent repair procedure carefully and without interruption.
-
Breaks longer than 10 seconds are considered and interruption in "activation mode".
-
Close door and turn ignition on.
-
Run window up to top position (fully closed).
-
Release window regulator switch.
-
Pull window regulator switch up again, and hold in position longer than 1 second.
-
Run window down to bottom position (fully open) by pressing window regulator switch down.
-
Run window up to top position (fully closed). Release window regulator switch.
-
Pull window regulator switch up again, and hold in position longer than 1 second.
-
Basic setting for window regulator is now activated.
-
Activate "one-touch" opening and closing function.
Basic Setting For Window Regulator Motor,clearing
NOTE:
-
This procedure may be necessary if basic setting is interpreted as being insufficient, (for example, following a seal replacement.).
-
This means, that the window may unintentionally reverse itself during closing.
CAUTION: The following procedures must be completed 3 times within one minute's time.
-
Close door and turn ignition on.
-
Open door window, and place a piece of wood (approx. 8-10 cm. high) between door window and upper door molding.
-
Close door window by pulling window regulator switch up.
-
Door window will stop upon contacting the wood, the pinch protection will activate and the window will reverse direction.
-
Close door window a second time by pulling window regulator switch up.
-
Door window will again stop upon contacting the wood, the pinch protection will again be activated, and the window will reverse direction.
-
Close door window a third time by pulling window regulator switch up.
-
The automatic reversing feature is now deactivated, and door window will remain in contact with the wood.
-
Door window will lower approx. .5 seconds after releasing door window regulator switch.
-
Close door window a fourth time by pulling window regulator switch up.
-
Door window will again stop upon contacting wood, but will not go down once window regulator switch is released.
-
Open door window by pressing window regulator switch.
-
Release window regulator switch.
-
Press window regulator switch down for at least 1 second.
-
Remove wood and close door window to top position (fully closed).
-
Release door window regulator switch.
-
Immediately pull window regulator switch up again for at least 1 second.
CAUTION: The previous procedures must be repeated two more times.
-
Activate basic setting for window regulator motor.