TT L4-1.8L Turbo (BEA) (2004)
Solenoid valves must only be threaded into the hydraulic pump in activated (energized state) using output Diagnostic Test Mode (DTM).
10 - Sealing ring for solenoid valve
-
Replace
11 - Sealing ring for oil reservoir
12 - Oil reservoir
-
Lightly oil sealing ring before assembly.
-
To assemble, twist oil reservoir while pushing on.
13 - Torx bolt
-
2 Nm
14 - Hydraulic pump
-
Remove convertible top before disassembly.
-
Removing. See: Convertible Top Pump/Service and Repair
15 - Oil filler plug
-
Oil level must be between "MIN" and "MAX" markings.
-
Oil for convertible top hydraulics: G 002 000
16 - Insulation
17 - Left hydraulic cylinder
-
With connection for microswitch.
Fig. 1 Line routing
-
Hydraulic pump with noise chamber -1-.
-
Hydraulic line to left cylinder with control wire for microswitch.
-
Wires must be unclipped from retaining clamps before removing hydraulic pump.