TT L4-1.8L Turbo (BEA) (2004)
Spoiler: Service and Repair
Spoiler Installing (Rear Lid With Pre-Drilled Locating Pin Holes)
Spoiler Installing (rear Lid With Pre-drilled Locating Pin Holes)
NOTES:
-
When installing spoiler on a new rear lid, prepare adhesive area with cleaning solution part number D 009 401 04B and prime area with special
primer part number D 181 711 A1.
-
Mark area to be primed using primer template V A.S 6043 for Audi TT rear spoiler.
-
When installing spoiler on a used and undamaged rear lid, do not totally remove adhesive residue.
-
Adhesive residue will aid in securing new adhesive applied.
Assembly overview
1
-
Spoiler
2
-
Gasket strip
-
Self-adhesive
-
Prior to attaching to spoiler, cut strip to length.
-
After spoiler has been painted, attach gasket strip as shown.
-
The ends of upper and lower strip must be set flush against each other.
3
-
Nut
4
-
Washer
-
Place onto adjusting screw after attaching gasket strip.
5
-
Gasket
-
Place on locating pin after attaching gasket strip.
6
-
Cover cap
-
Roadster only
7
-
Nut
8
-
Retainer screw