TT L4-1.8L Turbo (BEA) (2004)
![background image](/audi/tt/l4-1.8l_turbo_(bea)/Page-3085001.png)
Yaw Rate Sensor: Service and Repair
ESP Sensor Unit -G419-, Removing and Installing (ABS/ESP ITT Mark 60)
ESP sensor unit -G419-, removing and installing
(ABS/ESP ITT Mark 60)
Removing
^
Remove storage compartment on driver's side.
^
Remove bolts (arrows).
^
Pull ESP sensor unit -1- in direction of travel and out of holder.
^
Unplug electrical connector-2-.
Note:
^
The ESP sensor unit is not resistant to shocks or impact.
^
Do not install an ESP sensor which has dropped to the ground otherwise proper operation is not ensured.
Installing
Install in reverse sequence; note the following points:
^
Initiate basic setting for the sensors in the ESP sensor unit. See: Acceleration/Deceleration Sensor/Adjustments
^
Perform ESP road test.
Tightening torque