TT L4-1.8L Turbo (BEA) (2004)
-
Clean and smooth down sealing surface for O - ring as required.
-
Insert coolant thermostat.
Installation position: bowed metal strip on thermostat must be vertical.
-
Moisten new O ring with coolant G 012 AS D.
-
Tighten bolts.
-
Fill up with coolant. See: Service and Repair
Tightening Torque
Elbow connection to cylinder block: 15 Nm
Bracket for solenoid valves to intake manifold: 10 Nm
-
After connecting battery terminals, enter anti-theft code for radio.
Refer to radio operating instructions.
Warning: If a battery charger is used to give the engine an assisted start, there is a risk that the control units in the vehicle will be damaged.
-
Close electric windows in front doors all the way to their top positions using electric switches.
-
Then operate all electric window switches again for at least one second in the "close" direction to activate the automatic one-touch function.
-
Set clock to correct time.
-
Interrogate DTC memory:
Note: DTCs will have been stored in the memory because connectors have been disconnected. Therefore interrogate and erase DTC memory after
installing engine.
Testing Coolant Thermostat
-
Heat thermostat in water bath.
1) Cannot be tested.