TT L4-1.8L Turbo (BEA) (2004)
^
Cut off nozzle of tube at front marking (nozzle diameter approximately 3 mm).
^
The sealant should applied in a bead 2 - 3 mm wide - arrows -.
Notes: The bead of sealant must not be thicker than 3 mm, otherwise excess sealant can enter the sump and obstruct the filter screen in the oil
intake pipe.
^
Apply the bead of silicone sealant onto the clean sealing surfaces of the sealing flange, as illustrated. Fit the sealing flange immediately, and
tighten all bolts lightly.
Notes: To fit sealing flange with the oil seal already installed, use guide sleeve from 2080A.
^
Tighten bolts on sealing flange in diagonal sequence.
^
Install oil sump.
Notes: After installing, the sealant must be allowed to dry for about 30 minutes before putting in engine oil.
^
Install crankshaft sprocket.
Notes: Replace central bolt for sprocket.
^
Install toothed belt (adjust valve timing).
^
Install ribbed belt and tensioning element.
Tightening torques
^
Sealing flange to cylinder block: 15 Nm
^
Toothed belt sprocket to crankshaft: 90 Nm + additional 90°