TT L4-1.8L Turbo (BEA) (2004)
Air Register: Service and Repair
Undamaged Instrument Panel Vents, Removing And Installing
Undamaged Instrument Panel Vents, Removing And Installing
NOTE:
-
To remove an undamaged vent that will later be re-installed, press vent out of the instrument panel from behind. Removing it from the front of the
instrument panel could damage the vent.
-
To remove a damaged vent, use hooks -A-.
-
To gain access to the left vent, first remove storage compartment on the driver's side.
-
To gain access to the right- vent, first remove glove box.
-
To gain access to the center vents, first remove the center section of the instrument panel and also the switch panel.
-
Reach behind instrument panel from below and push vent -A- from opening in instrument panel.
NOTE:
-
When installing, make sure vent is the oriented properly (i.e. with tabs -B- towards bottom).
-
When installing, make sure locating piece -A- is inserted in slot -B- on instrument panel.