TT L4-1.8L Turbo (BEA) (2004)
If no malfunctions are found in the wires and there was voltage between terminals 1 + 3:
-
Replace Camshaft Position (CMP) Sensor -G40-.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes/Audi
Drive Cycle/Readiness Code/With Generic Scan Tool/Readiness Code, Generating
If no malfunctions are found in wires and there was no voltage between terminals 1 + 3:
-
Replace Engine Control Module (ECM).