TT L4-1.8L Turbo (BEA) (2004)
-
Connect VAG1527B voltage tester between sockets 2 (CMP sensor signal) and 1 (B+).
NOTE: Connector socket numbers are shown on rear side of connector.
-
Operate starter for a few seconds.
-
LED must blink.
NOTE: Voltage testers do not go out completely during low current pick-up between activations by ECM, but rather continue to glow a little and then
get significantly brighter during activation.
If LED does not blink:
Checking voltage supply
-
Disconnect connector at Camshaft Position (CMP) sensor.
-
Connect multimeter for voltage measurement as follows:
Harness connector
Measure to
Terminal
1
Engine Ground (GND)
-
Switch ignition on.
-
Specification: about 5 V
Checking signal wire
-
Connect multimeter for voltage measurement as follows:
Harness connector
Measure to
Terminal
2
Engine Ground (GND)
-
Switch ignition on.
-
Specification: approx. battery voltage
Checking Ground (GND) wire