TT L4-1.8L Turbo (BEA) (2004)
Clutch Slave Cylinder: Service and Repair
5-SPD Manual 02J FWD
Slave cylinder, removing and installing
Removing
-
Release hose clamp -4- and disconnect intake hose and electrical connector - 1 from air mass meter.
-
Remove hose -5- from air filter housing.
-
Unscrew bolts -2- and - 3 -, then remove air cleaner housing (complete).
-
Unbolt support bracket for gear selector cable from transmission and unclip hose (arrows).
-
Lever off gear selector cable - A - and gate selector cable - B - using an open - ended wrench -1 -.
1- Standard open - ended wrench (13 mm), commercially available
-
Remove bolts for slave cylinder (arrows).