TT L4-1.8L Turbo (BEA) (2004)
-
Remove flange shaft with spring.
-
Pull out seal.
Notes:
^
Do not damage sleeve, otherwise leaks will occur.
^
Replace sleeve if damaged.
Installing
-
Drive seal into sleeve onto stop. When doing this, do not cant seal.
-
Fill space between sealing lip and dust lip with multipurpose grease.
-
Insert flange shaft.
-
Install cone head bolt into flange shaft threaded piece.
-
Install left - hand drive axle or attach right - hand drive axle to flange shaft.
-
Install drive axle protective cap if necessary.
-
Top up transmission oil.
Tightening torques