TT L4-1.8L Turbo (BEA) (2004)
-
Pull out drive flange using special tool T10037.
-
Pry out drive flange oil seal using a suitable lever.
Installing
Installation is carried out in the reverse order, when doing this note the following:
-
Drive in new seal onto stop using special tool T10049.
-
Fill space between sealing lip and dust lip with multi-purpose grease.
-
Knock in drive flange, turning it at the same time.
-
Secure drive flange with cone head bolt.
-
Fit new seal on turbocharger oil return pipe and install.
-
Check oil in transmission with bevel box.
-
Fill up with engine oil:
Tightening torques