TT L4-1.8L Turbo (BEA) (2004)
-
Separate front exhaust pipe - A -.
-
Remove cross support - B - below exhaust system.
-
Loosen front part of heat shield - C -.
-
Remove heat shield - D -.
-
Unbolt gear stick housing from body.
-
Swing gear stick housing down and remove with selector cables.
Installing selector mechanism
Installation is carried out in the reverse sequence, when doing this note the following:
-
Align gear stick housing parallel to body.
-
Distance to body must be same on both sides.
-
Separate front exhaust pipe -A-.
Adjusting selector mechanism, Refer to Shift Lever, Adjustments.
-
Install complete air filter housing.
Tightening torques