TT Coupe L4-1.8L Turbo (ATC) (2001)
/Page-1320002.png)
^
Remove securing bolts from brake caliper housing. To do this counterhold guide pins.
^
Remove brake pads and pad retaining springs - arrows - .
^
Clean brake caliper housing, in particular bonding surface for brake pad. It must be free of adhesive and grease residues.
Use methylated spirit only for cleaning brake caliper housing.
Installing
Notes: Before pressing the piston back, draw off brake from the reservoir. Use a bleeder bottle or a plastic bottle which is only used for brake fluid.
Otherwise particularly if reservoir has been topped up, fluid will overflow and cause damage.
WARNING: Brake fluid is poisonous and must under no circumstances be sucked via a hose with the mouth.
^
Screw in piston by turning knurled wheel of special tool 3272 clockwise.
Notes:
^
Fit special tool 3272 so that the collar (arrow) of the tool is seated on the brake caliper.
^
If the piston is difficult to move, use a 13 mm AF open jaw wrench on the flats (arrow A) provided for this purpose.
^
If the piston is pushed back with a piston reseeing tool the automatic adjustment in the brake caliper will be destroyed.
^
Insert brake pads and brake pad retaining springs - arrows - into brake carrier.
^
Pull protective foil off outer brake pad backing plate.
^
Secure brake caliper housing with new self - locking bolts.
Notes: The repair kit includes four self - locking hexagon bolts which must be installed in all cases.
