TT Coupe L4-1.8L Turbo (ATC) (2001)
/Page-1348001.png)
Brake Master Cylinder: Service and Repair
Brake Master Cylinder, Removing and Installing
Special tools and workshop equipment required
^
3094 Hose clamps
Removing
^
Lay out sufficient lint free clothes in area of plenum chamber, engine and transmission.
^
Draw off as much brake fluid as possible from brake fluid reservoir using a suction bottle.
WARNING: Brake fluid is poisonous and must under no circumstances be sucked via a hose with the mouth.
^
Clamp clutch master cylinder supply hose with special tool 3094.
^
Pull off clutch master cylinder supply hose.
^
Pull connector off fluid level sender.
^
Disconnect brake lines on brake master cylinder and seal brake lines with plugs from repair kit 1 HO 698 311 A.
^
Unscrew brake master cylinder nuts.
^
Carefully take brake master cylinder out of brake servo unit.
Installing
Observe the following points when installing:
^
When fitting together the brake master cylinder and brake servo unit, ensure that the push rod is correctly located in the brake master cylinder.
^
After installing, bleed the brake system, Refer to Brake Bleeding, Service and Repair.
