TT Coupe L4-1.8L Turbo (ATC) (2001)
Installing
Install in reverse sequence; note the following points:
Note:
^
Only remove sealing plugs on new hydraulic unit when the corresponding brake line is going to be installed.
^
If the sealing plugs are removed too soon from the hydraulic unit, brake fluid may escape, it may no longer be possible to fill and bleed the unit
properly.
^
When assembling control module and hydraulic unit, make sure valve domes of hydraulic unit do not catch on control module solenoids.
^
Connect lines as previously marked.
^
Bolt ABS module to bracket.
Note: Do not fully tighten bolts. This facilitates attachment of individual brake lines to hydraulic unit.
^
After tightening brake lines, tighten hydraulic unit.
^
Bleed brake system.
^
If a new control module has been installed it must be coded.
^
After connecting brake lines to hydraulic unit, perform final control diagnosis.
Note: Final control diagnosis can be used to establish whether line connections have been interchanged.
Tightening torques