TT Coupe L4-1.8L Turbo (AWP) (2005)
Subframe: Removal and Replacement
Subframe, Removing and Installing
Subframe, removing and installing
Special tools, testers and auxiliary items required
^
Engine/transmission jack V.A.G 1383A
^
Support T10031
Removing
-
First remove spring.
-
Remove wheels.
Mark installation position before removing drive shaft - arrows -. This is important because excessive imbalance will occur if the installation position
is not correct.
-
Open double clamp behind catalytic converter and remove rear section of exhaust system.
-
Remove drive shaft from final drive.
1 -
Drive shaft with vibration dampener
2 -
Drive shaft flange
-
Remove heat shield for rear muffler.