TT Coupe L4-1.8L Turbo (AWP) (2005)
/Page-600003.png)
-
Push ring squarely from above down to approx. 15 mm from bottom end of cylinder. To do this use a piston without rings.
Fig. 2 Checking ring to groove clearance
-
Clean groove before checking clearance.
Fig. 3 Checking piston
-
Measure pistons approx. 10 mm from lower edge of skirt, at 90 degrees to piston pin axis.
Permissible deviation from nominal dimension: max. 0.04 mm
