TT Coupe L4-1.8L Turbo (AWP) (2005)
/Page-602001.png)
Crankshaft Gear/Sprocket: Service and Repair
Chain sprocket, removing and installing
Removing
-
Remove oil pan.
-
Remove front sealing flange.
-
Remove chain tensioner, oil pump sprocket and chain.
-
Pull chain sprocket off crankshaft with puller -2-.
-
Use suitable washer -1- to protect end of crankshaft.
Installing
-
Heat chain sprocket to 220 degrees C in oven.
WARNING!
Wear protective gloves.
Note:
Installation position: wide collar on sprocket facing toward engine.
-
Using pliers, locate sprocket on end of crankshaft and push onto seat on crankshaft with drift sleeve 30-100.
