TT Coupe L4-1.8L Turbo (AWP) (2005)
/Page-45003.png)
Display on VAS5051:
-
Check display values for throttle valve control module (display zones -3- and -4-).
NOTE:
-
The abbreviation "ADP" in display zone 4 stands for "Adaptation".
-
If the adaptation process is interrupted by the control module, the cause could be one of the following:
-
The throttle valve is unable to close completely (e.g. because of dirt).
-
Battery voltage too low.
-
Throttle valve control module or wiring is defective.
-
The engine was started or the accelerator depressed during the adaption process.
-
Distortion of throttle valve housing (check bolts).
When the adaptation process is interrupted the message "Function is unknown or cannot be carried out at the moment" will appear on the fault reader
display. The adaption process will start again automatically the next time the ignition is switched on (for several seconds).
-
Press the <- button to exit from the function "04 - Basic settings"
