TT Coupe L4-1.8L Turbo (AWP) (2005)
/Page-328007.png)
-
Remove lever/selector shaft -1 -.
-
Loosen both screws - B -.
NOTE: Do not unscrew screws completely.
-
Place T10173 adjustment gauge on selector shaft.
-
Turn Multi-Function Transmission Range (TR) Switch - A - until tab on connector - arrow 1 - engages in groove in adjustment gauge T10173.
If tab on connector cannot engage in groove in adjustment gauge, transmission is not in "N" position. In this case, transmission must be shifted to "N"
position using adjustment gauge:
-
To do this, turn adjustment gauge forward or back until connector tab - arrow 1 - can engage in groove in adjustment gauge T10173 (turn
Multi-Function Transmission Range (TR) Switch - A - slightly as well, if necessary).
-
Secure adjustment gauge T10173 to selector shaft with knurled thumb screw - C -.
-
Tighten both screws - B - to 5.5 Nm.
-
Remove adjustment gauge from selector shaft.
Rest of installation is the reverse of removal
