TT Coupe L4-1.8L Turbo (AWP) (2005)
Installing wheel bearing/wheel hub unit on stub axle
-
Install wheel bearing/wheel hub unit onto stub axle as far as it will go.
-
Install special tool 3420 and pull in wheel hub/wheel bearing unit as far as stop.
-
Remove special tool 3420.
-
Use a new 12-point nut and tighten to 220 Nm.
Driving in protective cap
Note:
^
Always replace damaged (dented) protective caps.
^
Damaged (dented) protective caps may allow moisture to enter the bearing. For this reason it is important to use the tool shown in the illustration.
Installation is in reverse sequence.