TT Coupe L4-1.8L Turbo (AWP) (2005)
/Page-1340003.png)
-
Bend hooks of locking washer - 2 - back using a screwdriver.
NOTE: If one or more hooks on lock washer are broken during bending, these must be replaced.
-
Remove nut - 3 - with washers - 2 - and -1 -.
-
Remove both screws - B - and pull Multi-Function Transmission Range (TR) Switch - A - upward over selector shaft.
Installing
Installation is performed in reverse order. When doing this note the following:
-
Place Multi-Function Transmission Range (TR) Switch -F125- on selector shaft.
-
Hand-tighten Multi-Function Transmission Range (TR) Switch fastening screws - B -.
-
Install washers -1 -, - 2 - and nut - 3 - on selector shaft.
Nut tightening torque: 7 Nm.
