TT Coupe L4-1.8L Turbo (AWP) (2005)
Pressing in wheel bearing
Coat entire inner surface of bore in wheel bearing housing with Molypaste (AOS 115 000 01).
Note: A grease packet containing 3 grams of grease is included with the wheel bearing kit.
Pressing in wheel bearing
-
Set up wheel bearing - 1 -, thrust piece - 2 - (install with collar in bearing) and hollow piston cylinder - 3 - with pull rod on wheel bearing housing.
-
Attach thrust piece - 4 - (with wide collar toward wheel bearing housing) and special nut - 5 - on inner side of wheel bearing housing.
-
Press in wheel bearing by actuating pump.
-
Insert securing ring with long-nose pliers.
1 -
Wheel bearing
2 -
Thrust piece E-13-1
3 -
Hollow piston cylinder HKZ-15
4 -
Thrust piece E-10
5 -
Special nut E-8-214 and pull rod
Pressing in wheel hub