TT Coupe L4-1.8L Turbo (AWP) (2005)
-
Attach centering piece with clamp E-76-2.
1 -
Hollow piston cylinder HKZ-15 with thrust piece E-0-204-T (hydraulic)
2 -
Centering piece with clamp E-76-2
-
Attach support - 1 -, hollow piston cylinder - 2 - with pull rod - 3 - and special nut - 4 -.
1 -
Support E40
2 -
Hollow piston cylinder HKZ-15
3 -
Pull rod E-0-217
4 -
Special nut E-8-214
5 -
High pressure hose with quick-release coupling
6 -
Thrust piece E-39
-
Build up pressure with foot-operated pump.
-
Check that all tools are correctly centered.
Note: Place engine/transmission jack V.A.G 13831A underneath (danger of accident from parts dropping out when wheel hub is pulled out).
-
Press wheel hub out of wheel bearing by pumping.
Pressing out wheel bearing
-
Remove circlip.
-
Position thrust piece - 1 - on rear side of wheel bearing.
-
Apply hollow piston cylinder - 2 - with pull rod - 3 - and special nut - 4 -.
-
Build up pressure with foot-operated pump.
-
Check that all tools are correctly centered.