TT Coupe L4-1.8L Turbo (AWP) (2005)
/Page-1371001.png)
Flex Plate: Service and Repair
Drive plate, removing and installing
Removing
-
Secure counter-hold tool VW 558 to drive plate with a hex bolt M8 x 45. Place two M10 hex nuts -1- between counter-hold tool and drive plate.
-
Loosen securing bolts on drive plate.
Installing
-
Install drive plate using packing plate with notches -1-.
-
Insert at least 3 of old securing bolts -3- and tighten to 30 Nm.
-
Check installation position of drive plate by measuring at three points and calculate average.
Specification: 19.5-21.1 mm
Note:
Measurement is taken through the hole in the drive plate to the machined surface of the cylinder block.
If the distance is too large:
