TT Coupe L4-2.0L Turbo (BPY) (2008)
Engine Accessory Bracket: Service and Repair
Accessory Assembly Bracket
Accessory Assembly Bracket
Special tools, testers and auxiliary items required
^
Locking Pin T10060A
Removing
^
Disconnect electrical connector on Mass Air Flow (MAF) Sensor G70 - 3 -.
^
Open clips - 1 and 2 - and remove air guide hose from mass air flow sensor.
^
Remove front air intake connector on lock carrier - 4 - See: Body and Frame/Radiator Support/Service and Repair
^
Remove engine cover.
^
Pull EVAP canister with connected lines upward - arrow - out of retainer and lay it aside.
Note:
^
Before removing ribbed belt, mark the turning direction on it with chalk or a felt tip pen. A reversed turning direction can cause damage to the belt
under operating conditions.