audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Terminal Housings, Release and Disassembly, General Information|Page 5312 > < Terminal Housings, Release and Disassembly, General Information|Page 5310
Page 1
background image

Wiring Harness: Removal and Replacement
5 Plug Relay Carrier, from 06.2008

5 Plug Relay Carrier, from 06.2008

Removing

-

Switch off ignition and remove ignition key.

-

Remove driver's storage compartment.

-

On a USA vehicle, remove the footwell air channel on the driver side.

-

Open the tab - 3 - with a screwdriver -  - and remove the 5-plug relay carrier - 2 - on the Vehicle Electrical System Control Module (J519) -  1 -.

-

Unclip fuse panel on relay carrier.

-

Detach relays and control modules and then unclip appropriate relay carrier.

‹› Check the exact assignment of 5-pin relay carrier in the current wiring diagram, Wiring diagrams, Troubleshooting & Component locations.

Installing

Install in reverse order of removal, observing the following:

-

On a USA vehicle, install the footwell air channel on the driver side.

-

Install driver's storage compartment.

Terminal Housings, Release and Disassembly, General Information|Page 5312 > < Terminal Housings, Release and Disassembly, General Information|Page 5310