TT Coupe L4-2.0L Turbo (BPY) (2008)
/Page-1721007.png)
-
Tension dial gauge to 1 mm pre-load.
-
Rotate to tighten steering rack using (V.A.G 1331) and (V.A.G 1923) on tie rod to 40 Nm in one direction. When (V.A.G 1331) disengages, set
dial gauge to " 0".
-
Now remove (V.A.G 1331) from tie rod.
-
Read off value indicated on dial gauge.
Specified value: 0.005 to 0.05 mm
-
Turn steering using (T10304) from left stop to right stop. Observe values indicating on dial gauge while doing this.
Specified value: 0.05 to 0.12 mm
‹› If specified values for steering rack play are not obtained, steering gear must be replaced completely!
-
Remove dial gauge and adapter, press rubber plug in adjustment screw.
-
Pull off left boot from steering gear housing.
-
Turn steering from left stop to right stop, while doing this grease visible area of steering rack with grease (G 052 192 A1) supplied.
CAUTION!
Do not use other grease under any circumstances.
-
Install left boot onto steering gear housing with new clamp.
-
Determine starting torque of steering.
