TT Coupe L4-2.0L Turbo (BPY) (2008)
/Page-1155002.png)
Loosen dust cap from seat by tapping lightly on claw of Grease Cap Puller VW 637/2.
-
Remove dust cap.
-
Remove brake caliper/brake carrier and suspend from body with wire.
Note:
^
Do not allow brake caliper to hang from brake line.
-
Remove Phillips screw for brake disc and take out brake disc.
-
Remove multi-point socket head bolt with Bit XZN 18 T10162.
-
Remove wheel bearing unit from stub axle.
Installing
Installation is in reverse order of removal, with special attention to the following:
Tightening torques, Subframe, diagonal brace, lower transverse link, upper transverse link, tie rod, level control system sensor (front wheel drive),
assembly overview
Make sure that wheel hubs/wheel bearing unit do not cant!
-
Tighten using a new multi-point socket head bolt.
Note:
^
First tighten the bolt to the given torque specification using the torque wrench.
^
Use solid wrench for additional torque angle.
