TT Quattro Coupe L4-1.8L Turbo (AWP) (2001)
-
Remove bolts for axle beam (arrows).
-
Slowly lower rear axle with transmission lift, e.g. VAG1383.
Installing
Remainder of installation is the reverse of removal.
-
Tighten bolts for subframe and mounting bracket in the pre - marked installation position.
After installing, camber and toe setting must be checked on an alignment stand.
Tightening torques:
Mounting bracket at mount, Tighten to 75 Nm
Always use new bolts
Subframe at attachment point, Tighten to 110 Nm + 90°
Always use new bolts
Drive shah to final drive, Tighten to 60 Nm
Suspension strut to longitudinal control arm, Tighten to 100 Nm + 90°