TT Quattro Coupe L4-1.8L Turbo (AWP) (2001)
Spoiler: Service and Repair
Spoiler, Installing (Rear Lid Without Pre-Drilled Locating Pin Holes)
Spoiler, Installing (rear Lid Without Pre-drilled Locating Pin Holes)
NOTE: Spoiler application requires use of special tool drill and assembly fixture, 66B2/00. Fixture is available for loan through your special tool
supplier.
-
Drill and assembly fixture 66 B2 / 00
-
Slide extension rests - 2 - over hatch rubber stop on left and right side.
-
Cover vehicle inside and out with paper - 2 - or optional cover V.A.S 5192 to prevent metal particles form getting into or scratching vehicle.
-
Apply adhesive tape - 1 - about 1 cm. wide - a - and 20 cm. long along both sides of lid edge to protect against paint damage.
NOTE: For Roaster lids, Coupe locating block (black) must be switched with locating block for Roadster (white).