TT Quattro Coupe L4-1.8L Turbo (AWP) (2001)
^
Remove remaining sealant from sump (with rotating plastic brush or similar).
WARNING: Wear eye protection.
^
Clean sealing surfaces: they must be free of oil and grease.
Installing
Notes: The sump must be installed within 5 minutes after applying the silicone sealant D176 404 A2.
^
Cut off nozzle on tube at front marking (nozzle diameter approximately 3 mm).
^
Thickness of sealant bead: 2 - 3 mm
Notes: The bead of sealant must not be thicker than 3 mm, otherwise excess sealant will enter the sump and obstruct the strainer in the oil intake
pipe.
^
Apply silicone sealant to the clean sealing surface on the sump as illustrated. The illustration shows the position of the sealant bead on the cylinder
block.
^
Apply the sealant bead with particular care around the rear sealing flange - arrows -.
^
Fit the sump immediately and bolt to cylinder block. Start by tightening all the bolts by hand.
^
Tighten the 3 bolts securing sump to gearbox.
^
Tighten bolts securing sump to cylinder block in two stages in diagonal sequence.