TT Quattro Coupe L4-1.8L Turbo (AWP) (2001)
Tail Lamp: Service and Repair
Rear Light Housing, Removing and Installing
Rear Light Housing, Removing And Installing
Removing
-
Open flap in luggage compartment side trim behind rear light (on left or right side).
-
Loosen two securing bolts -2-.
-
Ball pin -7- on rear light housing is just a press fit in clip -1-.
-
Disconnect electrical connection.
-
Pull out rear light from rear of vehicle.
Installing
-
Install in reverse order of removal, noting the following:
-
When installing, make sure that the seal between the body and the rear light housing is properly seated.
-
Before tightening securing bolts -2-, align rear light with body contours (uniform gaps all around).
-
Make sure that ball pin -7- is firmly located in plastic clip -1- (ball pin can be adjusted to align rear light with body).