TT Quattro Coupe L4-1.8L Turbo (AWP) (2001)
-
Unscrew nut on connecting link from left end of anti - roll bar. - Remove upper nut on left suspension ball joint.
-
Apply ball joint splitter as shown in illustration and press out ball joint.
Notes: To protect the thread, leave the nut screwed a few turns on the ball joint thread.
-
Turn the steering wheel all the way to the right.
-
Unbolt left drive axle at transmission, move clear and tie up
-
Place container under the transmission.
-
Remove cone head bolt for drive flange (counterhold with drift).
-
Pull out drive flange together with spring.
-
Lever out oil seal with a suitable lever.
Installing
Installation is carried out in the reverse order, when doing this note the following:
-
Drive in new oil seal onto stop using special tool 3339. Keep the seal straight when installing.
-
Fill space between sealing lip and dust lip with multi - purpose grease.
-
Press drive flange in firmly to overcome spring and secure with cone head bolt.
-
Install suspension ball joint and coupling link:
-
Check oil in transmission with bevel box.