TT Quattro Coupe L4-1.8L Turbo (BEA) (2003)
Fig. 2 Setting adjuster stops
-
Loosen clamping screw - 2 - and pull out adjuster stop slightly.
-
Close tailgate - 4 - and move to flush position; tailgate lock should engage in second stop in striker.
-
Now set adjuster stops - 3 - in correct position.
Fig. 3 Setting adjuster stops, continued
-
Open tailgate and pull out adjuster stop by one notch.
-
Tighten clamping screw - 2 - to 2 Nm.
-
To remove adjuster stop, drill out head from pop rivet - 1 - and knock shank out. Now take out adjuster stop.
-
Close tailgate.
-
Check panel gaps as shown.
Fig. 4 Disengaging and engaging cable
-
Rear lid lock removed.
-
Turn cable in support bracket 90 degrees and take out upward.
-
Swivel cable 90 degrees and take out of tailgate lock.