TT Quattro Coupe L4-1.8L Turbo (BEA) (2003)
Fuel Filler Neck: Service and Repair
FWD
Fuel filler tube, component overview
1. Pressure retention valve
^
Clipped to fuel filler unit
^
Closes vent line when vacuum from intake manifold is present
^
Only remove together with vent line and gravity valve
2. Change-over valve
3. O-rings
^
Different sizes
^
Always replace
4. Seal
^
Installed position: sealing lip faces fuel filler unit
5. O-ring
^
Always replace
6. Gravity valve
^
Only remove together with vent line and pressure retention valve
^
Checking, Refer to Fig. 2
^
To remove, unclip valve upward and lift out.
7. Ground (GND) connection
^
Installed position/check requirements, Refer to Fig. 1
^
Ensure secure fit of connector at metal ring of fuel filler unit
^
Securely tighten eyelet of electrical wire with cap nut,Refer to item - 8 -
^
After installing, check electrical connection of metal ring at fuel filler tube to a blank portion of chassis using multimeter:
^
Specified value: approximately 0 Ohms
8. Cap nut -10 Nm
9. Vent line
^
To EVAP canister