TT Quattro Coupe L4-1.8L Turbo (BEA) (2003)
/Page-2338008.png)
-
Similar screen appears.
^
ECM Part Number and old software level is still displayed at (arrows).
Note:
New software level is not displayed until process is complete and fault memories have been erased.
-
Select the "Print", then "Screen" button. + VAS 5051 will print to printer immediately.
^
VAS 5052 will hold the print until process is complete and then you may take the tester to the printer for printing the screen.
-
Attach print to vehicle Repair Order.
-
Select forward arrow > on navigation bar. Once "Update - Programming" (flashing) is complete, the control module must be re-initialized.
-
The tester requests you to switch the ignition OFF.
-
Switch ignition OFF.
^
The tester requests you to switch the ignition ON.
-
Wait 20 seconds and switch ignition ON.
After switching ignition ON, the ECM has been re-initialized, however, fault memories must now be erased.
Fault memories, erasing after "Update - Programming" (flashing)
-
Select the "Continue button" Due to the CAN bus system, fault messages will be stored in various Control Modules during programming.
