TT Quattro Coupe L4-1.8L Turbo (BEA) (2003)
/Page-646002.png)
8. 4-pin harness connector
9. 11 Nm
10. Cap nut - 10 Nm
11. Ground (GND) connection
^
Installed position/test requirements, Refer to Fig 1
^
Check for tight fit of connector at metal ring of filler tube.
^
Securely tighten screw eyelet of electrical wire using cap nut item 14.
^
After installing, check electrical connection of metal ring at fuel filler tube to a blank portion of chassis using multimeter:
^
Specified value: approximately 0 Ohms
12. Nut -10 Nm
13. Bracket
^
For fuel filler tube
14. Sealing cap
^
With seal
15. Tensioning ring
^
Large diameter
16. Tensioning ring
^
Small diameter
17. Rubber cup
^
With overflow hose
18. Vent line
^
White
^
From EVAP canister
^
To Evaporative Emission (EVAP) canister purge regulator valve -N80
19. Vent line
^
To EVAP canister
^
Only remove together with tank protection valve and gravity valve
20. Fuel tank
21. 26 Nm
22. Mounting straps
23. 26 Nm
24. Clamping washer
^
Removing: turn to left
^
Installing: tighten to 2 Nm
25. 26 Nm
Fig. 1 Installation position of Ground (GND) connection
^
Route Ground (GND) connection as shown in figure.
^
Ensure connector -2- of Ground (GND) connection fits securely at metal ring -1- of fuel filler tube.
^
Disconnect Ground (GND) connection at both retaining clips (arrow).
Note: Depending on construction version, a cable binder may be implemented in place of a clip.
