TT Quattro Coupe L4-1.8L Turbo (BEA) (2003)
-
Set up thrust piece - 1 - with collar facing wheel bearing' press sleeve - 2 - with four internal stepped diameters toward wheel bearing housing and
hollow piston cylinder - 3 - with pull rod and special nut - 4 -.
-
Operate pump and pull out the wheel bearing.
1 - Thrust piece E - 5
2 - Press sleeve E - 65 -1
3 - Hollow piston cylinder HKZ- 15
4 - Special nut E - 8 - 214 and pull rod
Pulling inner race off hub
-
Apply special tool 3423 as shown.
-
Screw cross - piece Kukko 18 - 0 into special tool 3423.
-
Apply special tool 40 - 105 to wheel hub and pull off bearing inner race by turning threaded spindle.
Pressing in wheel bearing
-
Coat complete inside surface of wheel bearing housing with MoS2 grease (AOS 115 000 01)
Notes: A grease pad (3 grams) is supplied with replacement wheel bearings.