TT Quattro Coupe V6-3.2L (BHE) (2005)
Spoiler: Service and Repair
Spoiler, Installing (Rear Lid With Pre Drilled Locating Pin Holes)
Spoiler, Installing
Rear lid with pre-drilled locating pin holes
-
Place pins - 3 - into holes of lid - 4 -.
-
Place spoiler - 1 - onto rear lid.
-
Hold spoiler in position and open rear lid.
Tightening sequence for nut
-
A second person is required to hold spoiler in correct position, while another screws lock nuts onto outer studs of spoiler, tightening only to hold
spoiler in position.
-
Apply small amount of thread lock compound to middle studs to secure nuts.
-
Screw nuts - 1 - onto inner studs - 2 - until torx splines - arrow - are clear.
-
Using torx socket E5, turn stud - 2 - counter clockwise until stud is in contact with reinforcement panel - 4 -.
-
Hold stud - 2 - torx socket (E5) and tighten nut - 1 - using offset box end wrench.
-
Measure gap - a - using adjustment gauge 3371.
-
Gap - a - should be 1 mm + 1 mm.
-
If gap is correct and there is no viable distortion in outer panel of lid, tighten outer nuts to 5 Nm.
-
If gap is not correct, loosen nuts and adjust gap.