TT Quattro Coupe V6-3.2L (BHE) (2005)
-
If installed, disconnect secondary air intake hose -1- from air cleaner.
-
Disconnect air hose -2- from mass air flow sensor.
-
Unplug connector -3- from mass air flow sensor.
-
Unscrew bolts -4- and -5-.
-
Remove air cleaner housing.
-
Lay out sufficient lint-free cloths in area below brake master cylinder to catch escaping brake fluid.
-
Draw off as much brake fluid as possible from brake fluid reservoir using Brake Filler and Bleeder Unit VAS 5234.
-
Pull connector off relevant pressure sender (the one to be removed) - arrows -.
-
a - Brake Pressure Sensor 1 G201 in primary piston circuit
-
b - Brake Pressure Sensor 2 G214 in secondary piston circuit
-
Remove brake pressure sender.
Installing
Install in reverse sequence; note the following points:
-
Bleed brake system
-
Bleed hydraulic system for clutch
-
Initiate basic settings for brake pressure sensors.
-
Perform ESP road test. See: Antilock Brakes / Traction Control Systems/Description and Operation/General Information
Tightening Specification