TT Quattro Coupe V6-3.2L (BHE) (2005)
/Page-1473003.png)
-
Disconnect brake lines -1- from hydraulic unit to brake master cylinder and tie up.
-
Disconnect remaining brake lines from hydraulic unit.
CAUTION
Take care not to bend brake lines in the vicinity of the hydraulic unit.
-
Seal brake lines and threaded holes with plugs from repair set.
-
Unscrew bolts at hydraulic unit - arrows - and take out hydraulic unit and control module.
Control Module from Hydraulic Unit, Removing
-
Place hydraulic unit with control module down on a clean flat surface.
-
Remove Torx socket head bolts - arrows -.
CAUTION
The hydraulic pump must not be separated from the hydraulic unit.
-
Separate hydraulic unit with hydraulic pump from control module by lifting carefully off joint -1-.
-
When detaching control module, make sure valve domes of hydraulic unit do not catch on control module solenoids.
-
Cover control unit solenoids with a lint free cloth.
-
Protect components against moisture.
-
Install transportation protection for valve domes (enclosed in repair kit) after separating control module and hydraulic unit.
Note:
