TT Quattro Coupe V6-3.2L (BHE) (2005)
Steering Angle Sensor: Removal and Replacement
Steering Angle Sensor, Removing and Installing
Note:
^
The coil connector with slip ring is enclosed in the housing of the steering angle sensor G85.
Removing
-
Turn wheels to straight ahead position.
-
Removing airbag unit and steering wheel.
-
Remove storage compartment on drivers side.
-
Remove bolts -1- and detach handle for steering column adjustment -5-.
-
Remove bolts -2- to -4-.
-
Remove upper and lower sections of steering column trim.
-
Disconnect electrical connectors -1- and -2-.
-
Carefully lift upper retainer tabs - arrows.
-
Carefully lift lower retainer tabs and pull off housing with coil connector, slip ring and steering angle sensor from steering column switch.
Installing
Install in reverse sequence; note the following points: