TT Quattro Coupe V6-3.2L (BHE) (2005)
/Page-656002.png)
^
To remove it is first necessary to remove both upper and lower covers for timing chains
9 - Pivot pin
10 - Chain tensioner for camshaft timing chain, 40 Nm
11 - Seal
^
Replace if damaged or leaking
12 - Sprocket for drive chain for valve gear
13 - Sprocket for camshaft timing chain
14 - 60 Nm + 90 degrees (1/4 turn) further
^
Replace
^
When loosening and tightening, counterhold vibration damper with counterhold tool T10069
15 - Chain tensioner with guide rail
^
For drive chain
^
Before installing, release locking spline in chain tensioner with a small screwdriver and press guide rail against chain tensioner
16 - Drive sprocket chain
^
Integral part of chain
17 - Drive chain for valve gear
^
Mark rotation direction before removing Go to Fig. 1
18 - Guide rail for drive chain for valve gear
19 - Pin, 10 Nm
^
For guide rail
20 - 18 Nm
21 - 23 Nm
22 - Camshaft adjuster - intake
^
Identification: 24E
23 - 60 Nm + 90 degrees (1/4 turn) further
^
Replace
^
Contact surface of sender wheel at bolt head must be dry when installing
^
To remove and install: counterhold with 32 mm open end wrench on camshaft
24 - Guide rail for camshaft timing chain
