TT Quattro Coupe V6-3.2L (BHE) (2005)
Tire Pressure Sensor: Service and Repair
Changing Tires
Changing Tires
Nickel-plated valve insert must be replaced with every tire change.
Metal valve and wheel electronics can be reused
-
Let air out of tire by removing nickel-plated valve insert.
-
Tires, dismounting
-
Perform a visual inspection for loose or damaged parts. If there are loose threaded connections, replace entire valve unit.
Note: Damaged wheel electronics must be replaced.
-
Tires, mounting
-
Install new nickel-plated valve insert.
-
Fill tires, reinstall plastic cap.
-
Balance tires.
Dismounting Tire
Roll or press tires off.
When using pressure paddles, first separate tires from side opposite of valve.
Do not use pressure paddles in hatched area - a -.
-
Position mounting head near valve so that tire iron can be put on approx. 30° - b - next to tire valve.
-
Then remove tire in valve area first.
Mounting Tire
Do not use pressure paddles in valve area.
-
Position wheel electronics approx. 180° opposite of mounting head.
-
Press tire in bed approx. 90° in front of mounting head - arrow -.
-
Mount tire.